Lights

Q) Why do exterior fixture bulbs burn out so often?
A) This is usually caused by several factors:
Use of non-brand named bulbs.
Larger wattage bulbs, which cause excessive heat build-up shorting the life of the bulb. Power Surges.
Q) Who do I call if I have problems with my telephone wiring within my house?
A) With deregulation of the utility companies in most areas of the country, the cable or telephone companies are no longer responsible for the equipment or wiring in your home. This responsibility has fallen to you and your electrical contractor. Therefore, when a problem arises, we recommend you us. Most TV and telephone utilities will still service within your home for a substantial fee. This service, as in the past, is no longer free.
Q) Why does my recess can light cycle on and off after putting a larger wattage bulb in?
A) Modern Recess Cans are rated for a maximum wattage bulb and are equipped with a thermal device that does not allow a bulb larger than that rating. If a larger wattage bulb is used, as the excess heat builds up, the thermal device will shut the can off until it cools. This is a safety device to protect your home against fire.
Q) Will a surge/lightening protection device totally protect my home from lightening strikes?

A) No – not “totally.” Surge/Lightning Protection only offers additional levels of protection. Nothing can guarantee completely against Mother Nature and where she chooses to strike.

Q) Can I use the same outlet for my coffee pot and toaster oven?
A) Yes, but if the two loads exceed 20 Amps, your breaker will sense overload, do its job, and trip off. Under this condition, you must plug one of the appliances into a different kitchen outlet on a different circuit, in order to balance the load.
Q) Can I dim fluorescent lights?
A) Yes. Dimming fluorescent requires not only a special dimmer, but also special fixtures. You cannot place a typical incandescent dimmer on existing fluorescent.
Q) Can I hang a ceiling fan where a light is?
A) Yes, but first you must make sure the electrical box is properly braced and rated for the weight and torque of the ceiling fan you are installing.